How to install the board hanger

How to install the board hanger

Jeroen Luitwieler

BoardHangers are a two-piece wall-mounting system for displaying your kiteboard or snowboard. Both mounts are fixed to the wall with two screws and must be level and securely attached.

Mounting options: kiteboards and snowboards can be displayed horizontally. Vertical mounting is only supported for kiteboards.

What you'll need

  • Drill and a suitable drill bit
  • Screwdriver
  • Spirit level
  • Tape measure
  • Pencil
  • Wall detector for checking pipes and electrical cables
  • 4 screws and 4 wall plugs (included)

Calculate the distance between the mounts

Horizontal mounting

Measure the length of your board and divide it by three. The result is the centre-to-centre distance between the two mounts.

Example: for a 120 cm board, position the centres of the mounts 40 cm apart.

Vertical mounting — kiteboards only

Measure the distance between the relevant fins and subtract 4 cm. The result is the centre-to-centre distance between the two mounts.

Example: if the distance between the fins is 30 cm, position the centres of the mounts 26 cm apart.

Installation

  1. Choose where you want to display your board. Check that there is enough space around it and that the wall can support its weight.
  2. Choose horizontal or vertical mounting and calculate the required distance between the mounts using the instructions above.
  3. Use a wall detector to check for pipes and electrical cables before drilling.
  4. Hold the first mount against the wall and mark both screw holes with a pencil.
  5. Drill the holes using a drill bit suitable for your wall and wall plugs.
  6. Insert the wall plugs and secure the first mount with two screws. Check that it is straight and firmly attached.
  7. Measure the required centre-to-centre distance and mark the position of the second mount.
  8. Use a spirit level to make sure both mounts are horizontally aligned.
  9. Drill the remaining holes and secure the second mount.
  10. Carefully place your board on the mounts and confirm that both sides support it evenly.

Important mounting advice

  • Always use screws and wall plugs suitable for your wall type and the weight of your board.
  • The supplied fixings may not be suitable for every wall. Brick, concrete, hollow walls and metal surfaces can require different hardware.
  • Do not use vertical mounting for snowboards.
  • Check the screws and mounts periodically, especially after moving or replacing the board.
  • If you are unsure about the wall or required fixings, ask a professional installer for advice.
Back to blog